Quick Answer: What transmission fits a 350 small block?

The 350 has had TH200 , TH350, TH400 , 4L60 and more than likely the 4L80 automatics behind it. My truck with the Chevrolet 350 engine utlizes the TH400 . There would have been a variety of manual gear boxes behind the 350 as well.

What transmission works with a Chevy 350?

The TH350 transmission was introduced in the 1969 model year as the successor to the GM Powerglide automatic transmission. Jointly developed by Chevy and Buick, it is also referred to as the CBC (Chevrolet-Buick Combined) 350. The Turbo 350 quickly become known for its strength, versatility and compactness.

Will a 4L60E transmission fit a 350?

Premium Member. The 4L60E will bolt straight up to your 350. :yes: You will need some way to control the tranny though. The OD is electronically controlled, hence the “E” at the end of the 4L60.

What transmission can replace a TH350?

TH200-R4 is the other common retrofit option for a TH350. Pluses and minuses to both conversions, probably about the same $$. I went with up-rated 200-R4 to replace TH400 because it was a straight bolt in.

THIS IS EXCITING:  Does burnt transmission fluid mean the transmission is bad?

Will a t56 fit a Chevy 350?

the t56 will bolt directly to the sbc with no mods. You will need one out of a lt1 or you will have to spend bank on a new bellhousing and other junk. You can use a stock lt1 flywheel if you have a 1 piece rear main seal. If not you need to by a flywheels that has the right bolt pattern.

Are all TH350 transmissions the same?

Externally, all the TH350 transmissions look the same; however, internally there are some differences. Depending on the engine size of the car the transmission was removed from, it can have anywhere from 10 to 18 friction discs and 10 to 18 steel clutch plates inside.

How much HP can a TH350 handle?

The Stage 1 TH350 is rated up to 450 hp. Those seeking something a little stronger can check out the Stage 2 version (PN PA35102) that holds 550 hp and retails for $1,500 with a real world street price of $1,175 from most vendors.

Can I swap a TH350 for a 4L60E?

TH350s installed in trucks used a long tailshaft, making them the same overall length as a 700-R4 and 4L60E overdrive, while the TH350 installed in car is shorter. … That means this driveshaft will need to be shortened.

What’s the difference between 4L60 and 4L60E?

The rear output housing is configured with a six-bolt pattern in late model 4L60E transmissions. The 4L60 transmission is configured with a four-bolt pattern. The bolt pattern is not a guaranteed distinction, however, as early 4L60E transmissions, manufactured from 1992 through 1997, also have a four-bolt pattern.

THIS IS EXCITING:  Best answer: Do technicians make more than engineers?

Will a 700R4 replace a TH350?

If your original TH350 came with a 6-inch tail shaft, you’ll have to cut the drive shaft by 3 inches. … The 700R4’s drive shaft yoke is identical to the TH350’s, so your old yoke should work nicely with the new transmission.

Will a 400 transmission fit a 350?

Does a 400 small block mount on a transmission work the same as a 350 block? – Quora. Assuming that you are referring to Chevrolet engines, yes, it is the same.

What vehicles have a Turbo 350 transmission?

The Turbo 350 Transmission found excellent use in Pontiac Firebirds, GMC trucks, Chevrolet Camaros, Monte Carlo, and the Caprice. This transmission remarkably matches GM automobiles with small-block V-8s as well as the small Iron Duke 4-cylinder models, the block-block 396 V-8s, and V-6s.

How do I tell what size transmission I have?

Open the driver’s side door and find the white card on the side of the door that is filled with small black lettering. This card contains specific details about the year the car was made, its transmission, engine specifications and other details.

Is the T56 a good transmission?

“Once you get to about 700 horsepower, the T56 is done,” says Rodney Massengale, at RPM Transmissions, in Anderson, Indiana. “It’s a very good transmission, but just wasn’t designed for the kind of power that LS engines have been pumping out for the last few years.” And what about the Viper version of the T56?

Will a T56 bolt up to lt1?

As far as manual transmissions go, the T56 Magnum 6-speed from Tremec is the unequivocal king. Fortunately, the newer the vehicle, the more likely the beefy T56 will fit. …

THIS IS EXCITING:  Do Advance Auto Parts employees get a discount?

Can you put a T56 on a SBC?

If you’re starting from scratch and already have a 3 or 4 speed manual transmission in the car, the easiest and cleanest way to swap a T56 into a first generation Camaro behind a traditional BBC/SBC is as follows: You will need an LS1 T56, the McLeod adapter kit (1/2” thick adapter plate that goes between the …